All About Handyman Services Press News

Solid Advice When It Comes To Plumbing

Nov 26

Many people attempt to do their own plumbing in order to save money on repair costs. They often fail due to a lack of proper plumbing knowledge or by using the wrong tools for the job. If you would like to do your own plumbing without doing more harm than good, then read the tips in the following article.

Do not try to sell a product that you do not agree with. This includes paying attention to the company itself and their values and policies. If you have any qualms about the company, your customers will pick up on it. You want to be a full supporter of the product you are selling

Harrellsville Plumbing Service

You need to winter-proof your house. You have to make sure you switch of the master circuit breaker or the shut-off valve before you leave your house. Since one small hole or congested water can quickly freeze and cause pipes to break and expand, you need to drain and open all outdoor and household water lines.

Check how well your toilets are flushing. If the handle needs to be played with in order to keep the water from running constantly, or if it needs to be held down several times in order to flush, you may need to switch out some of the parts in your tank. This is not expensive, and it could help reduce your monthly water bill. It could also mean that you avoid the embarrassment of the flushing system breaking when you have visitors!

If your toilet will not flush, and there is very little water in the basin, try to fix the issue by dumping warm water in the bowl from around your waist line. Repeat this as many times as necessary until your clog is gone, and you can flush normally once again.

If you have well water and discover orange or pink discoloration on your bathtub or sink, you probably have iron in your water supply. A water softener is the easiest way to solve hard water problems relating to rust, but you can also consult a plumber if you are unsure.

Make sure everyone in your home knows where the main water shut off valve is and that they know how to work it. That way, if there is a water problem, anyone in your household can turn off the water, thereby reducing the chances that your home will incur major water damage.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

You should drain all of the water out of the tank of your hot water heater at least once every three to six months. Draining all of the water out of the tank helps to prevent sediment build-up at the bottom of the tank. This sediment can cause the tank to bang or to heat less efficiently.

Make sure that your tool box is ready for any project you are preparing to do. The last thing you want is to be knee deep in a job only to find that you are missing the one tool you need to finish. Be sure to have various sizes of pipe wrenches that can be used to complete any job.

Be sure to check your dryer and clear your lint trap of any debris. This will help your dryer to work better and may also prevent fires. Make sure that you inspect the lint trap for any holes or tears that might mean lint is going to your pipes, which might lead to clogs and other problems to deal with.

If you are using PEX tubing for the supply lines in your home, make sure you get the right tools for the job. PEX tubing requires a completely different tool type than regular lines. PEX has a lot of benefits though, so don't let the different requirements throw you off.

Keep an eye on the hoses for your dishwasher and washing machine. These hoses can leak and bulge, which can be a problem. Check them for signs of wear and tear and replace any hoses more than 10 years old. You'll find that these hoses age well, but you have got to make sure they are doing the job they should.

While you may not be able to tackle every problem that comes up, you can surely feel more confident about dealing with some of the basic stuff. Take any situation step by step, and you will find that it's not as difficult as you may have thought.

Harrellsville, NC

Harrellsville Plumbing Service